Instruction Winter Car Wash Soap

Foam Cannon Use:

1. Dilute: Add 2 oz of Salt Crusher to 16 oz of water in the foam cannon.

2. Pre-Rinse: Rinse the vehicle to remove loose dirt and grime.

3. Apply Foam: Spray the foam mixture evenly over the vehicle and let it sit for 1-2 minutes.

4. Rinse & Dry: Rinse thoroughly, then dry with a clean microfiber towel for a spotless finish.

1. Dilute: Mix 2 oz of Salt Crusher per 2 gallons of water in a wash bucket.

2. Pre-Rinse: Rinse the vehicle to remove loose dirt.

3. Wash: Apply the solution with a microfiber cloth or sponge, gently scrubbing to lift salt and grime.

4. Rinse & Dry: Rinse well, then dry with a microfiber towel for a clean, streak-free finish.

1. Pre-Rinse: Using a hose or pressure washer, thoroughly rinse the undercarriage to remove loose salt, dirt, and debris.

2. Apply Salt Crusher Solution: Spray a diluted solution (2 oz per 16 oz water) on the undercarriage, covering all exposed metal areas.

3. Let Sit & Rinse: Allow the solution to sit for 1-2 minutes to break down salt and grime. Rinse thoroughly with a pressure washer or hose.

Use warm water when diluting Salt Crusher for all applications.
Wash in small sections and rinse each section immediately to reduce freezing risks.
Dry each section with a microfiber towel right after rinsing to prevent ice spots.

Avoid freezing
If in eyes, rinse immediately with water and seek medical attention if irritation persists.
Rinse off skin thoroughly after contact.
Store in a dry place away from direct sunlight. Ensure the container is tightly sealed when not in use.